Specifications
* LED Quantity/Type: 150xSMD5050 RGB
* Input Voltage (to power supply): 100-240VAC, 50/60Hz
* Power: 36W
* LED Strip Width: 10mm
* LED Strip Length: 16.4ft (5m)
Items Included
* (1x) 16.4 feet RGB LED strip with self adhesive tape on the back
* (1x) Controller and 44-button wireless IR remote
* (1x) Power supply
Wiring
* Unroll LED strip completely.
* Any exposed wires on the other end of the LED strip must not touch one another (or any metal object), creating a short.
* Connect the 4-pin connector of controller to that of the LED strip, making sure that the arrows line up.
* Connect 5mm DC jack of power supply to controller.
* Remove the plastic seal in the battery compartment of the wireless remote.
* Double check that all connections are correct and secure, then plug in power cord.
Note
* While the included controller can handle the power requirement of two such strips, the power supply only has the capacity to drive a single strip.
* Do not lengthen the LED strip by directly connecting an additional section to it.
* Extension kits are available for adding additional strips.
* Test all components before permanent installation.
* Make sure that wires at the other end of the LED strip are not touching one another (or any metal object), which would create a short circuit. Electrical tape may be used to wrap each of those wire ends to isolate them.
* The LED strip is cuttable every 3 LEDs, approx. every 4″, at the designated cut marks.
Product Features
- Complete kit includes LED strip, controller, and power supply
- Set static colors, adjust brightness, select various auto color changing modes via wireless remote
- LED strip is cuttable and linkable (required components not included, combined length should not exceed 16ft)
- Flexible – fits just about any space you can imagine
- Eco friendly – uses very little energy, without harmful radiations
Great product for a great price 0
Great lights, 5 minute set up! 0
Comments are disabled for this post.