Attach a spotlight anywhere: to your house, to your office building, in your warehouse, shed, garage, porch, entryway, or even a tree. Mr. Beams offers simple installation with no wiring and no electrician needed. Tight seals and weather-resistant materials allow a Mr. Beams Mini Spotlight to work in all weather conditions. The Mini Spotlight is designed to an IP55 level of water resistance.

The Mr. Beams Mini Spotlight has one bright power LEDs providing 80 lumens of bright white light. The typical light color is a neutral white at a color temperature of 4000K. The durable, bright LEDs never need replacing–it’s so efficient that you will get more than 3,600 activations on one set of batteries. The Mini Spotlight instantly turns on when it detects motion and can detect motion from as far as 25 feet away with 160 degrees of vision. It turns off automatically after 30 seconds of no motion, conserving battery life.

These are fantastic bright indoor and outdoor motion sensor battery powered lights for over a door, in a closet, stairways, attics, basements, utility rooms, storage rooms, sheds, garages or for adding outdoor lights in any convenient location around the house. Also great for use in commercial properties, in warehouses and storage rooms. The Mini Spotlight from Mr. Beams is wireless and requires no wiring. Simply insert batteries and attach to any surface. Attach these Spotlights anywhere in minutes without an electrician. The mounting bracket and simple thumbscrew adjustment allow the light output and motion sensor detection to be adjusted to cover the area where it is needed. A built-in photocell activates the motion sensor only after the sun has set. The MB316 is weatherproof for year-round illumination.

The battery powered motion sensor LED mini spotlight has a photocell inside that activates the LED when it is somewhat dark to conserve battery life. This is often referred to as a ‘dusk-to-dawn’ sensor because if it is used outdoors, it will start to work early in the evening through to the morning when it starts to get light out. It does not have to be complete darkness as the light sensor will enable the light if the detected light level is low (with a light intensity below about 3.5 lux at the light). To test the mini spotlight before installation or at any time, it’s recommended to put fresh batteries in and take it into a dark room. Leave the room to avoid your motion retriggering it. The light should shut off after a minute or two if the light is working properly (the motion sensor may need time to settle immediately after putting the batteries in). When you walk into the room, the motion sensor should trigger turning the light on.