This is an outdoor pump. 120VAC 4 speed Jebao water pump.

Pump Flow Rate: 105 GPH. Max head: 26″.

Pump Size: 2″x1.5″x2″(H)

Tube connector 5/16″(diameter)

Plug Wire Length:
Approx. 60in

If your fountain has a rubber stopper with the pump cord that goes through….
Rubber Stopper Exchange Instructions (DRAIN PLUG)

The rubber stopper is part of the fountain, not the pump. It needs to be removed from the old cord and installed on the new one. This can be done by removing (cutting them off) the plugs.

1. Cut the old cord right where the stopper connects to it.

2. Gently twist and pry the rubber stopper off. If it does not come apart, as a last resort, you can slice the stopper, carefully with a razor, where it attaches to the cord (do not slice entire stopper). This can be fixed as later explained.

3. Cut the plug off of your new pump as close to the plug as possible. Slide stopper onto new pump cord to desired location and seal it with silicone (and/or waterproof tape if available) if necessary.

4. A new plug can be purchased at your local hardware store for under $5 and easily wired onto the new pump cord. If you are not familiar with wiring, we recommend hiring a licensed electrician or someone with wiring experience.

5. If you had to slice the stopper as earlier described, it is best to seal with a few wraps of waterproof tape (not electrical tape) Please contact us for special waterproof tape if necessary

6. When wrapping tape around cord be carful not to let tape stick or bond to itself. Tape has no adhesive but is difficult to undo once it has bonded together. It will only take 3 or 4 wraps to complete the process.

Share Button