Product Name: Submersible Pump
Ultra-quiet Mini Submersible Pump Compact Multifunctional Detachable
SPECIFICATION
Max Flow Rate: 1500L/H
Max Lift Height: 2.0m
Power: 25W
Voltage: 110-120V/60Hz
Length of Power Cord: 1.8m
Dimension: 83mm x 58mm x 68mm
OPERATE
Neither clog up the entrance of the pump nor suck any dirty liquids.
Should the pump be used on a dirty surface, lift it a bit so that a contact with debris is avoided.
To lower the flood of water, use the control lever located on the side of the pump.
Immerse the pump into the water before connecting it to the plug.
At the very beginning, the pump may not work out properly as it might have some air inside,
So just take it off the water and immerse it again: it will surely work out.
PRECAUTIONS
Always disconnect the plug before handling the pump.
Do not use it without water.
Do not grab it using its cable.
Use only cold water.
Use the pump only if completely immersed.
UPKEEP
Remove the frontal part of the pump and the fan and wash them under flowing water.
Do not remove the drum of the pump.
Remove the frontal part and check that the fan runs the proper way.
Check the pump monthly and make sure the pump and its exit are free of obstruction.
QUALITY GUARANTEE
This water pump is designed for reliability to provide 18-Month Worry-Free Warranty.
If there are any quality problem, we offer a free replacement or full refund within three months.
Product Features
- Energy-saving low power, keep reliability and low noise operation, giving you quiet environment.
- No need any tools to detach it, easy to separate, easy to clean.
- This submersible pump is great for aquarium, fountains, spout and hydroponic systems.
- Designed with a adjusting knob, allowing to adjust the water flow rate.
- Rubber suction cups can be a good fit in the glass surface, to help keep it stability.
For the price it is OK. It pushes water through. You get what you pay for. We purchased this to add a small cascade to a bird bath. The flow is adequate even at the lowest level. The barbed adapter just sits in the slot and is very easily dislodged. You also need small ID 1/2 aquarium tubing or similar to make any sort of extension work. All we had around was polyethylene irrigation tubing and the 1/2″ .600 ID is way too large. (there are three common sizes of 1/2 inch polyethylene irrigation tubing, the smallest ID of the three might…
Lower flow rate…
Comments are disabled for this post.