Attach a spotlight anywhere: to your house, to your office building, in your warehouse, shed, garage, porch, entryway, or even a tree. Mr. Beams offers simple installation with no wiring and no electrician needed. Tight seals and weather-resistant materials allow a Mr. Beams spotlight to work in all weather conditions. The MB380 is designed to an IP66 level of water resistance.

Two bright power LEDs provide 300 lumens of bright white light making the MB383 one of the brightest wireless spotlights on the market. The bright LEDs never need replacing–it’s so efficient that you will get more than 3,600 activations on one set of batteries. The spotlight instantly turns on when it detects motion, and can detect motion from as far as 25 feet away with 160 degrees of vision. The spotlight turns off automatically after 20 seconds of no motion, conserving battery life.

The MB383 from Mr. Beams is an ultra bright battery-powered, wireless, motion-sensor LED spotlight that requires no wiring. Simply insert batteries and attach to any surface. A built-in photocell activates the motion sensor only after the sun has set. These are fantastic and bright outdoor security lights for yard, doorways, garage, and playground. The MB383 is weatherproof for year-round illumination. Attach these Spotlights anywhere in minutes without an electrician.

The MB383 motion sensor LED spotlight has a photocell inside that activates the LED when it is somewhat dark to conserve battery life. This is often referred to as a ‘dusk-to-dawn’ sensor because if it is used outdoors, it will start to work early in the evening through to the morning when it starts to get light out. It does not have to be complete darkness as the light sensor will enable the light if the detected light level is low (with a light intensity below about 3.5 lux at the light). To test the MB383 before installation or at any time, it’s recommended to put fresh batteries in and take it into a dark room. Leave the room to avoid your motion retriggering it. The light should shut off after a minute or two if the light is working properly (the motion sensor may need time to settle immediately after putting the batteries in). When you walk into the room, the motion sensor should trigger turning the light on.