){kind=link}
Let-60 Watt class 2 12 Volt ac standard version transformer features electronic internal resettable protection. Patented auto heat regulation also acts as overload protection. Auto-reset thermal cut-off at 125c. Waterproof potting. Aluminum casing. Maximum load: 60 watts. Minimum load w/o dimmer: 10 watts. Minimum load with dimmer: 20 watts. Input: 120 volts, 60 hz. Input current at max load: 0.5 amps. Output at maxload: 11.75 volts, 40 khz, 5 amps. Dimmable with low voltage electronic dimmer. UL and cUL listed. Lead wire is 6 inches long. 2 inches wide x 1 inch high x 3/4 inch deep.
Product Features
- Max 60 watt 12 volt AC Class 2 Electronic Transformer
- Input: 120 Volts, 60 Hz, 0.5 Amps
- Output: 11.75 volts, 40 kHz, 5 Amps
- UL and cUL listed; For 12V Halogen
- check lightology.com for deals
Related posts:
LET-75 12V AC Class 2 Electronic Remote Transformer by Lightech
Low Voltage Transformer for Malibu Outdoor Lighting Systems
BMOUO 100V – 240V To DC 12V 5A 60W Switching Power Supply Adapter For LED strip Flexible Light, 5.5×2.1mm DC Output Jack
Kichler 15M100AZT Manual Series 100-Watt Transformer
Light with 15 Leds without Transformer (Set of 1)
Ledwholesalers 30 Watt LED Power Suppply Driver Transformer 120 to 12 Volt DC Output, 3207
Low cost, easy solution Purchased this as a replacement when the low voltage transformer for our undercounter kitchen lights went out. Installed a couple of weeks ago and working fine.
When we remodeled our kitchen a few years ago, we spent a pretty penny from a local lighting showroom on Kichler under counter xenon 12v lighting. In less than a year one of the lights would randomly wink out. Sometimes for days. With some struggle the show room replaced that light. A year later it went out again, and then all but one of the others exhibited the same problem over time.The problem: the transformers.This LET-60 is the perfect replacement at a fraction of the cost of a new fixture. All you need to do is remove a few screws to get to the interior of your light. Make note of roughly where the wires are stuffed so you can get it all fitted again, then untuck them all. Slide a knife under the old transformer and pry up to separate it from the double sided tape. Swap it out for the new LET-60 and stick it back down on the tape. Tuck and reassemble. All done for $14!
Comments are disabled for this post.